Instructions / Assembly
19
PB 9210 Assembly Instructions
Swing Beam Drill Locations
6WHSTap t-nut into 3/8’’ hole as shown in )LJ.
2. Step 2: Place a bottom beam clamp over the swing hanger as shown in )LJ.
6WHSInsert the swing hanger into the beam and thread it into the T-nut until it is flush or near flush with the top of the T-nut. A
screwdriver may be used to twist the hanger )LJ. Orient swing hanger as shown
in )LJ.
4. Step 4: Use (4) 1-1/4’’ screws to secure beam clamp.
Check hanger to ensure it does not spin.
Repeat for all swing hangers.
(4) 1-1/4'' screws
Swing Hanger
Use Screwdriver to aid in tightening
Bottom Beam Clamp
t-nut
Hammer
3/8'' hole
T-nut
)LJ