Installation Guide

SWING BEAM SWING HANGERS - INSTALL
You may need to tap with hammer to get though holes.
Swing Hanger Bolt
Flat Washer
Spring Clip
Swing Hanger
Swing Hanger
Swing Beam
Flat Washer
Final position of each Spring Clip is
perpendicular to swing beam.
IMPORTANT!
Lock Nut
Cap
1-3/8"
Washer
2 Threads MIN.
Use a socket
wrench to tighten
Lock Nut securely
against washer.
Swing Hanger Bolt must protrude at least
TWO Threads beyond Lock Nut.
IMPORTANT!
Lock Nut
1-3/8" Washer
HOLD position of
Swing Hanger while
tightening Lock Nut.
Final position of each Spring Clip is
perpendicular to swing beam.
IMPORTANT!
x1
3-3/8 x 5-3/ x 95"
2502-CC
2194
x4
NOTE: You may need to tap hanger with a hammer to get through beam.
SWING BEAM SWING HANGERS
Lock Nut
Cap
1-3/8"
Washer
2 Threads MIN.
Use a socket
wrench to tighten
Lock Nut securely
against washer.
Place Cap on threads
after tightening
Swing Hanger Bolt must protrude at least
TWO Threads beyond Lock Nut.
IMPORTANT!
Lock Nut
1-3/8" Washer
HOLD position of
Swing Hanger while
tightening Lock Nut.
Final position of each Spring Clip is
perpendicular to swing beam.
Swing Beam
IMPORTANT!
x1
3-3/8 x 5-3/ x 95"
2502-CC
1. Attach Swing Hanger(s) to swing beam as shown.
PF 6299
2 5/8’’x 5-3/8’’x 93’’
Swing Beam
1-1/4" SCREW AND SWING HANGER ADDEDNDUM
!! IMPORTANT - READ THIS ADDENDUM FIRST !!!!
THERE ARE NO 1-1/4" WOOD SCREWS IN THE FASTENER BAGS. YOU WILL USE THE 1-3/16" SCREWS.
USE THIS SWING HANGER INSTALL ADDENDUM IN PLACE OF THE SWING HANGER INSTALL METHOD IN
YOUR PLAYSET INSTRUCTIONS. YOU MUST USE THE QUICK LINK SUPPLIED TO INSTALL YOUR SWINGS.
© Swing-N-Slide Inc.
LDR 7-10-2018
LA 9466
Cap
1-1/4”
1-3/16”
WHEREVER YOUR INSTRUCTIONS
CALLOUT USING THE 1-1/4"
SCREW USE THE 1-3/16" SCREW
ere are NO 1-1/4” screws included with the hardware bags to assemble the playset. Use the 1-3/16” (30mm)
screws provided in the hardware bag(s) whereever a 1-1/4”, 1-3/16”, or 30mm screw is called out.
1-1/4” Screws running change:
(30 mm)