Instructions / Assembly

DO NOT FULLY TIGHTEN CARRIAGE BOLT AT THIS TIME.
STEP 6: SWING BEAM ASSEMBLY
LAY A-FRAME ON THE GROUND WITH ANGLED BRACKETS FACING UP.1.
POSITION SWING BEAM ASSEMBLY RESTING UPON A-FRAME.2.
ALIGN HOLES AND INSERT CARRIAGE BOLT.3.
YOU MAY NEED TO TAP BOLTS WITH
HAMMER TO GET THROUGH HOLES.
3/8" FLAT WASHER X 1
X 13/8' LOCK NUT
3/8 X 3-1/4" CARRIAGE BOLT X 1
13