Instructions / Assembly

9
USE THE CORRECT FASTENER
Use the guides below to help select the correct length, quantity & location of
screws for the board installation.
Avoid splitting your lumber by offsetting your screws at least 3/4” from edge.
All hardware should be driven until ush with the surface or no deeper than 1/16”.
1x4 to 2x4 & 3x3
(3) 2-1/2” screws
per attachment point
1x4 to 1x4
(2) 30mm screws
per attachment point
English(*) Metric(Cm) English(*) Metric(Cm)
1x42.5x10.25/8x3-3/8 1.59x8.57
1x52.5x12.75/8x4-1/2 1.59x11.43
5/4x43.2x10.21x3-1/2 2.5x8.89
5/4x63.2x15.31x5-1/2 2.5x14
2x25x5 1-1/2x1-1/23.8x3.8
2x35x7.6 1-1/2x2-1/23.8x6.4
2x45x101-1/2x3-1/2 3.8x9
2x65x15.31-1/2x5-1/2 3.8x14
3x37.6x7.6
4x410x10 3-1/2x3-1/29x9
(*) Estimated Sizing Due to Cutting Process
NOMINAL MATERIAL SIZE
LISTED SIZE
T RUE SIZE
7.6x7.6
3x3