Instructions / Assembly

16
Assembly Instructions
2'' Lag screw
(2)
1-1/4'' lag screws
(12)
2'' lag screws
Slide Installation
1. Lift and attach 5’ Turbo to units, as shown in
(Fig. 9).
Note: Two people will be required to properly
align the Turbo Tube Slide with your tower.
2. On either side of the Slide Entrance there is a
dimple. Insert (1) 2'' Screw in either side, so
that the screw goes into the support board
behind, as shown in (Fig. 9a).
3. Secure Elbow Bracket to 2'’ x 4'' as shown in
(Fig. 9b).
Note: The lower edge of the E
lbow Bracket
must
sit tightly against the top of the 2'' x 4''
support board.
1-1/4'' Lag screw
bRACKET SHOUl D bE TIGHT
AGAINST 2'' x 4''
Fig. 9
UNDER DECK VIEW
Fl USH
Fl USH
Fig. 9b
Approximate
1-1/4''
Gap
2'' screw
2'' x 4''
(1)
2'' screw
per side
Fig. 9a