Instructions / Assembly

13
Assembly Instructions
Assembly Instructions
Fig. 6
Slide Barrier Construction
1. Carefully remove your Barrier Support Boards
from the barrier where you would like to place
your slide, making certain you will have a clear
72'' Safety Zone for your slide. (Fig. 6).
Retain this lumber and fasteners as you will need
them in a later step.
2. Cut to length and install (2) 2'' x 4'' Barrier
Support Boards as shown in (Fig. 6a), making
certain the opening between them is 25''.
3. Cut (1) 2'' x
4'' Barrier Board to the height of
your
barrier railing and create a slide opening of
23'', as shown in (Fig. 6a).
4. Reattach your barrier boards, making certain
they are evenly spaced and do not have a gap
larger than 3'' between each board, as shown in
(Fig. 6a).
Fig. 6a
2-1/2'' screw
2'' x 4''
Cut To Width of Your Unit
(3)
2-1/2''
screws
per joint
25''
23''
3-1/4'' Gap
Between Each
Barrier Board
2'' x 4''
Cut To Width of Your Unit
NOTE:
This plan uses a generic tower to
illustrate the 5' Turbo Tube Slide being
attached. However, this same procedure
is to be used for any Swing-N-Slide
5’ Tower Playset.
5' DECK HEIGHT
2'' x 4''
Barrier Board
Cut to Height
of Rail
(4)
2-1/2''
screws
per barrier
board