Instructions / Assembly

34
TUBE ASSEMBLY (CONT.)
5. Position the exit section to the previously
attached sections so the seams line up.
Rotate the section two holes to the left
(counterclockwise) and realign with the
holes of the entrance section (see
FIGURE 9).
6. Insert a 3/4" bolt through a washer,
through the slide sections, a second
washer and secure with a loc nut.
NOTE: Hand tighten the loc nuts only at
this time.
7. Position the slide base to the slide
assembly as indicated in FIGURE 10.
8. Insert a 3/4" bolt through a washer,
through the slide sections, a second
washer and secure with a loc nut.
9. Tighten all of the bolts of the slide
sections securely at this time.
NOTE: Do not tighten the bolts of the
mounting plate at this time.
FIGURE. 9
FIGURE 10
Rotate seam two
holes to the left
(counterclockwise)
Girar el dobladillo
de los agujeros a la
izquierda
Tourner de deux
trous vers la
gauche (sens
contraire à celui
des aiguilles
d'une montre)
dimple
marke
encoche
dimple
marke
encoche
hole
perfore
trou
ASSEMBLY INSTRUCTIONS