Instructions / Assembly

FIGURE 1

FIGURE 2

FIGURE 3

Entrance Section - 14 bolts

Sección de Entrada - 14 pernos

Section d’entrée - 14 boulons

flanged lip

labio levantado

bord relevé

flat lip

labio plano

bord plat

Exit Section - 13 bolts

Sección de salida-13 pernos

Section de sortie - 13 boulons

90° Section (2 are required) - 13 bolts each

Sección 90° (se requieren 2) - 13 pernos cada una

Section à 90° (2 requises) - 13 boulons chacune

loc nut

tuerca

écrou de blocage

washer arandela rondelle

3/4" bolt

3/4" perno

boulon de 3/4 po

ENTRANCE SECTION, 90° SECTION (2)

AND EXIT SECTION

NOTES:

• At least two individuals are needed to

assemble the Turbo Tube Slide.

• To aid in aligning holes when assembling

sections, insert a screwdriver through adjacent

holes to maintain hole alignment.

1. Identify each slide section as either (1), (2),

(3), (4), (5), or (6) as marked on the lip of each

piece.

2. Assemble entrance section using pieces (1) &

(2), two 90° sections using pieces (3) & (4),

and the exit section using pieces (3) & (5).

Join sections using a 3/4" hex head bolt, two

flat washers, and a loc nut at each hole

junction (FIGURES 1, 2 & 3). NOTE: Fasten

each loc nut finger tight until the entire slide is

assembled. Each time you join parts be sure

each flanged lip is mating with a flat lip.

ASSEMBLY INSTRUCTIONS