User Manual

4. Press to configure time of the active lap

5. Press “C” to confirm lap time of the active lap and move to next lap

6. Press “OK” to confirm the configuration and start the multi lap mode

Rerun Multi Lap from memory

1. Press “B” to start the multi lap mode configuration

2. It shows the active lap number to configure and lap time.

3. Press “B” again to start the multi lap mode with the last configuration stored in memory

Cancel an active lap or multi lap run

1. While in an active lap or multi lap run press to cancel and return to wall clock mode

Turn OFF display

1. Press “D” to cancel any run and turn off display

Turn ON display

1. Press any of “D”, , “A” or “B” to turn on the display and enter the respective mode

Turn ON display

FCC Warning Statement

Changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment. This equipment has been tested and

found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-- Consult the dealer or an experienced radio/TV technician for help.