Swimnerd Pace Clock User Interface Manual
Contents OVERVIEW ............................................................................................................................................................. 2 SETTING UP PACE CLOCK .................................................................................................................................................2 MODES OF THE CLOCK ..................................................................................................................................................
Overview Setting up Pace Clock The pace clock is powered with the provided wall adapter. The pace clock can be controller using the provided IR remote controller or using an Android phone or an iPhone over BLE. This document describes in detail the various mode of operation and controlling the pace clock using the IR remote control or the phone. Modes of the Clock The clock has multiple modes of operation. The following are the details 1.
Using IR Remote Key Functionality Mapping Key A B C D Function Initiate configuration of pace clock for Lap mode Initiate configuration of pace clock for Multi Lap mode Context aware Configure/Confirm function Display ON/OFF control Go to Wall Clock mode or Pace Clock mode if already in wall clock mode Confirm a selected configuration and start the mode Change the selected digit up or down Select the digit to configure while in a configuration mode OK Configure Wall Clock Time 1. 2. 3. 4.
4. Press to configure time of the active lap 5. Press “C” to confirm lap time of the active lap and move to next lap 6. Press “OK” to confirm the configuration and start the multi lap mode Rerun Multi Lap from memory 1. Press “B” to start the multi lap mode configuration 2. It shows the active lap number to configure and lap time. 3. Press “B” again to start the multi lap mode with the last configuration stored in memory Cancel an active lap or multi lap run 1.
