Specifications

SAFETY INFORMATION
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. This device complies with Part 15 of the FCC rules and with
Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploita-
tion est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le
fonctionnement.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
Your device is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to
radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government. The FCC has established
criteria for the amount of radio frequency energy various
products may produce depending on their intended usage. This
product has been evaluated and found to comply with the FCC’s
exposure criteria. For body worn operation, the FCC RF exposure
guidelines were also met when used with the accessories
supplied or designed for this product. Use of other accessories
may not ensure compliance with FCC RF exposure guidelines
and should be avoided.
Caution: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user’s
authority to operate this device.
This device must not be co-located with other transmitters. The
installer of this radio equipment must ensure that the antenna is
located or pointed such that it does not emit RF field in excess of
Health Canada limits for the general population; consult Safety
Code 6, obtainable from Health Canada’s website:
www.hc-sc.gc.ca/rpb
IMPORTANT NOTE
The Zygo Headset is rated to IP68 which guarantees protection
in water up to 1.5 meters for up to 30 minutes.
The Zygo Transmitter is rated to IP67 which guarantees protec-
tion in water up to 1 meter for up to 30 minutes.
The Zygo Charging Case is splash proof and should not be
submerged in water.
The antennas used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons
and must not be located or operating in conjunction with any
other antenna or transmitter.
Les antennes utilisées pour ce transmetteur doivent être installé
en considérant une distance de séparation de toute personnes
d’au moins 20 cm et ne doivent pas être localisé ou utilisé en
conflit avec tout autre antenne ou transmetteur.
Voluntary Licensing of Licence-Exempt Wireless Microphones in
the TV Bands.
This device operates on a no-interference, no-protection basis.
Should the user seek to obtain protection from other radio services
operating in the same TV bands, a radio licence is required. For
further details, consult Innovation, Science and Economic
Development Canada’s Client Procedures Circular CPC-2-1-28,