Installation Guide

For the #10-24 x 2” screw, the 10-24 brass insert, and the 10 x 7/16 washer
4. Place a #10-24 x 2” screw through a 10-24 brass insert and insert the screw and insert into the appropriate
screw hole in the system base (Figure 13).
5. Using a Phillips head screwdriver, drive the screw into the hole in the system base until the top of the brass
insert is flush with the system base (Figure 14).
6. Back the screw out, leaving the brass insert imbedded in the system base (Figure 15).
7. Repeat steps 4 through 6 for the screw hole located 180° from the already installed brass insert (Figure 16).
8. Place the filter tank foot on the filter end of the system base and align the two screw holes in the tank foot
with the two holes in the system base that now contain the brass inserts.
Figure 13
Figure 14
Figure 15
Figure 16
Both brass inserts in place
6