Installation Guide

6. The top of the brass insert should be flush with the system base (Figure 10).
7. Repeat steps 4 through 6 for the screw hole located 180° from the already installed brass insert (Figure 11).
8. Place the filter tank foot on the filter end of the system base and align the two screw holes in the tank foot
with the two holes in the system base that now contain the brass inserts.
9. Install a screw and washer through one of the screw holes in the tank foot. Tighten the screw into the brass
insert in the system base (Figure 12). Repeat with the other hole located 180° opposite the first one.
Figure 10
Figure 11
Both brass inserts in place
Figure 12
5