Installation Guide

Figure 1

Pump end

of system base

Filter end

of system base

Orient the pump

with the strainer

pot facing in the

direction of the

arrow

Release latch

Claw fasteners

Introduction

The aboveground system mounting base installation kit contains everything you need to configure and

position select Pentair aboveground pool pump/filter systems on a level area intended for use as the

equipment pad for the pool.

Installation

WARNING! Risk of electrical shock or electrocution.

1. Make sure all electrical breakers and switches to the pump are turned off , and disconnect the

communication cable from the pump before installing the base.

Seat the pump

1. Orient the pump so that the pump strainer pot faces in the direction of the arrow in Figure 1.

2. Slide the pump foot between the claw fasteners and the release latch (Figure 2). Seat the pump by

pushing down on it until the release latch clicks into place on the pump foot (Figure 3).

Figure 2

Claw fastenersRelease latch

Figure 3

Claw fastenersRelease latch

Pump foot