Owner's manual

Swiftech Inc., 1703 E. 28
th
St., Signal Hill, CA 90755 T. [phone] F. [phone] - 3 -
BEFORE YOU BEGIN!
Components installation
1. Open the side-panel #21 by loosening thumb screws #32
2. Remove the main cross bar #27.
3. A special memory board cross bar (#37) specific to server applications is provided with the lose parts. It is not shown in the schematic above,
and can be safely discarded in most consumer applications.
4. Loosen screw #33, and remove the front bezel #1
5. Remove the top cover #17
You now have full access inside the case to proceed with the installation of your power-supply, motherboard, hard drive (s) and various components.
Liquid cooling circuit notes
• The water-block is installed onto the back-panel for safe shipping. Unscrew the 4 springs assemblies, and remove the four standoffs used to
secure the block onto the back-panel. You will need these standoffs later, together with the spring and screw assemblies to install the water-
block to your motherboard.
• During installation of your motherboard inside the case, it is good practice to strap the block out of the way, using a rubber band for example.
• Your cooling circuit is already filled with coolant (90% pure water, 10% coolant). All you need to do is to install the water-block to your CPU.
Please follow the separate installation guides for AMD or INTEL processors.
• Power to the pump: a spare power cord is provided to supply A/C power to the pump. It needs to be connected to an A/C outlet.
Water-block pre-installation notes:
Intel
®
processors
The MCW462 water-block is shipped with Intel
®
Pentium
®
4 brackets pre-installed. These brackets feature different mounting holes to accommodate
Intel’s various mounting form factors. Please refer to the Intel
®
installation guide below, to identify the holes that will be needed for your particular
motherboard.
AMD
®
process ors
Please remove the Intel
®
Pentium
®
4 brackets from the MCW 462 water-block, using the provided socket wrench, then follow the AMD
®
installation guide
below.
Parts list
Parts AMD INTEL QTY PARTS AMD INTEL QTY
Water-block Common to both 1 6-32 lock-nuts Common to both 4
6-32 x 1 ½” screws (for HS) Common to both 4 Black fiber washers X 8
Standoffs Common to both 4 Thermal grease Common to both 1
Springs Common to both 4 Tube insert Common to both 2
Nylon flat washers X 8 P4 brackets X 2
Nylon shoulder washers X 4 4-40 socket screws X 4