Owner's manual

Rouchon Industries, Inc., dba Swiftech – 1703 E. 28

Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769

E Mail: Swiftech @swiftnets.com – URL: http://www.swiftnets.com

Page 1

Packing list

Parts Qty Parts Qty

Heat Sink 1 Fan & fan guard 1

Spring loaded screw assemblies 2 Thermal grease – Céramique 1

Heat sink Installation

1. The case should be laying flat on a table.

2. Lightly coat the CPU with the provided Céramique™ thermal compound. Detailed instructions can be found at

http://www.arcticsilver.com/ceramique_instructions.htm

Rub some compound in base

of water-block first, and then

clean off with lint-free cloth.

Apply small amount of

compound on the CPU heat

spreader

6-32x1 7/8“

p h ilip s sc re w

Washer

Spring

Tension lim iter

Heatsink assy.

Motherboard assy.

Pla stic re te ntio n fra m

& backplate

sold separately

Figure 1

Information subject to change without notice

PAGE 1
Packing list Parts Heat Sink Spring loaded screw assemblies Qty 1 2 Parts Fan & fan guard Thermal grease – Céramique Qty 1 1 Heat sink Installation 1. The case should be laying flat on a table. 2. Lightly coat the CPU with the provided Céramique™ thermal compound. Detailed instructions can be found at http://www.arcticsilver.com/ceramique_instructions.htm Rub some compound in base of water-block first, and then clean off with lint-free cloth.
PAGE 2
3. Heatsink installation Simply place the heatsink onto the processor as shown in Figure 1, page 1, and gradually tighten the spring loaded screws: Tighten one side a few turns, then switch to the other side and tighten a few turns, and continue this procedure until full tension has been reached.