Instruction Manual

Rouchon Industries, Inc., dba Swiftech – 1703 E. 28

Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769

E Mail: Swiftech @swiftnets.com – URL: http://www.swiftnets.com

Information subject to change without notice

Page 1

Packing list

Parts Qty Parts Qty

Heat Sink 1 Push-pin rivets (standard) 4

80mm fan brackets 4 6-32 x 1” Philips screws (80x25mm fans) 4

Thermal grease – Arctic Alumina 1 6-32 x 1.75” Philips screws (80x 38mm fans) 4

#6 nylon nuts 4

Fan

Push-pin

Retention Frame

MCX603 heatsink

Spring clip

Fan bracket

PAGE 1
Packing list Parts Heat Sink 80mm fan brackets Thermal grease – Arctic Alumina Qty 1 4 1 Parts Push-pin rivets (standard) 6-32 x 1” Philips screws (80x25mm fans) 6-32 x 1.75” Philips screws (80x 38mm fans) #6 nylon nuts Qty 4 4 4 4 Fan Push-pin Spring clip Fan bracket MCX603 heatsink Retention Frame Copyright Swiftech 2003 – All rights reserved – Last revision date: July 2, 2003 Page Rouchon Industries, Inc., dba Swiftech – 1703 E. 28th Street, Signal Hill, CA 90755 – Tel.
PAGE 2
1. Processor Preparation Lightly coat the processor core with the provided Arctic Alumina thermal compound. Only a paper thin coat is necessary. It should be applied using preferably a razor blade, or a credit card, held between thumb and index at a 45° angle. It is critical to ascertain that the entire core is covered with a uniform coat of thermal compound. Thermal performance will dramatically decrease if any portion of the core is not covered by thermal compound. 2.