Owner manual

Rouchon Industries, Inc., dba Swiftech – 1703 E. 28

Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769

E Mail: Swiftech @swiftnets.com – URL: http://www.swiftnets.com

Page 1

Packing list

Parts Qty Parts Qty

Heat Sink 1 80mm fan straight brackets - pre-installed 4

Spring clips 2 Snap-rivets (for fan installation) 4

92mm fan brackets 4 Thermal grease – Céramique 1

I. Heat sink Installation

1. The case should be laying flat on a table. Remove the existing heatsink.

2. Clean up the processor surface with alcohol, and lightly coat it with the provided Céramique  thermal compound. Detailed

instructions can be found at http://www.arcticsilver.com/ceramique_instructions.htm

3. The MCX478-V heatsink ships with 80mm fan brackets pre-installed. You will need to remove them, and install the included 92mm

brackets if you plan on using a 92mm fan. Use a thin screwdriver to remove and install the brackets, so as to not damage the

surrounding pins.

80mm fan straight bracket (as shipped)

92mm fan bracket

Fa n

Snap-rivet

Sp ring C lip

M C X478-V

heatsink

Sto c k re te n tio n

fra m e

CPU

Motherboard

IRFLOW DIRECTION

Figure 1

Information subject to change without notice

PAGE 1
Packing list Parts Heat Sink Spring clips 92mm fan brackets Qty 1 2 4 Parts 80mm fan straight brackets - pre-installed Snap-rivets (for fan installation) Thermal grease – Céramique Qty 4 4 1 I. Heat sink Installation 1. The case should be laying flat on a table. Remove the existing heatsink. 2. Clean up the processor surface with alcohol, and lightly coat it with the provided Céramique  thermal compound. Detailed instructions can be found at http://www.arcticsilver.com/ceramique_instructions.htm 3.
PAGE 2
4. 5. 5. Position the heatsink inside the retention frame as shown figure 1. Engage the end of each spring clip into the holes of the retention frame posts. While holding down the opposite side of the heatsink to prevent it from tilting, push down on the first spring clip’s thumb bracket to engage the other end. Then do the same with the second clip. The heatsink is now securely attached to the retention frame.