Manual

Parts list

Parts QTY PARTS QTY

MCW6000 or 6002-A™ water-block 1 Retention spring/clip assemblies 2

Worm drive clamps 2 SK7 hold-down plate 1

Céramique thermal compound 1

This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to

your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their installation. The

following instructions are subject to change without notice. Please visit our web site at www.swiftnets.com

for updates.

6-32 x 1.00" philips

3-T c lip

MCW6000-A water-blo

socket 462 motherb

socket "Cambox"

Step side over "Cambox"

INLET

DISCHARGE

STIFF spring

black color

SOFT spring

metallic color

SK7 hold-down plate

Figure 1

Rouchon Industries, Inc., dba Swiftech – 1703 E. 28

Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E

Mail: Swiftech@swiftnets.com – URL: http://www.swiftnets.com

- Information subject to change without notice

Page 1 of 3

PAGE 1
Parts list Parts MCW6000 or 6002-A™ water-block Worm drive clamps Céramique thermal compound QTY 1 2 1 PARTS Retention spring/clip assemblies SK7 hold-down plate QTY 2 1 This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their installation.
PAGE 2
1. Preparing your Motherboard Remove the existing heat sink and carefully clean the CPU. Apply thermal compound: lightly coat the CPU with the provided Céramique™ thermal compound. Follow this link http://www.arcticsilver.com/ceramique_instructions.htm for detailed instructions. Apply small amount of compound on the CPU heat spreader Rub some compound in base of waterblock first, and then clean off with lintfree cloth 2.
PAGE 3
Place the MCW6000 or 6002-A over the CPU as shown in figure 1 page 1. The water-block step side MUST be located over the socket cam box. A label affixed to the base of the water-block clearly identifies which side this is. The retention clips should snap over each side, and hook onto the socket tabs. Make sure that the clips are properly aligned to fit snugly underneath the tabs.