Instruction Manual

1. Preparing your Motherboard
 Remove the existing heat sink, and carefully clean the CPU.
 Apply thermal compound: lightly coat the CPU with the provided Céramique™ thermal compound. Follow this link
http://www.arcticsilver.com/ceramique_instructions.htm
for detailed instructions.
Rub some compound in base of water-
block first, and then clean off with lint-
free cloth
Apply small amount of
compound on the CPU heat
spreader
Parts list
Parts QTY PARTS QTY
MCW6000™ or 6002-64™ water-block 1 Retention springs & screws 2
Worm drive clamps 2 SK8 hold-down plate 1
Céramique thermal compound 1
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to
your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their installation. The
following instructions are subject to change without notice. Please visit our web site at www.swiftnets.com
for updates.
4
5
6
7
8
2
1
3
3
ITEM NO. Q TY. PART NO. DESC R IPTIO N
1 1 MCW6000-R2 MCW6000 flat base water-block
2 1 S754-RETENTION-r2 SK8 hold-down plate for AMD K8
3 1 K8_Motherboard
A
MD K8 (Athlon 64 & Op teron) m otherboard+ processor assy.
1 counter-plate
1 motherboard
1 retention-frame
4 2 91772A158-6-32X1.75 6-32 x 1 7/8“ philips screw
5 2 93286A041-WASHER zinc plated washer
62885 spring
7 2 spacer-205x140x773 tension limiter
8 2 6-32 nylon retaining washer 6-32 nylon retaining washer
Figure 1
Copyright Swiftech 2004 – All rights reserved – Last revision date: 11-23-04
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. [phone] – Fax [phone] - E Mail:
[e-mail] – URL: http://www.swiftnets.com - Information subject to change without notice