Instruction Manual

Copyright Swiftech 2006 - All rights reserved - Last revision date: 1-17-06 - One or more Patents Pending
Rouchon Industries, Inc., dba Swiftech - 1703 E. 28th Street, Signal Hill, CA 90755 - Tel. [phone] - Fax [phone] -
E Mail: [e-mail] - URL: http://www.swiftnets.com - Information subject to change without notice
Installation with nVidia GeForce 6800 to 7800 series
& ATI X1300 and above
(four mounting holes)
ITEM NO. PART NUMBER DESCRIPTION QTY
.
1 2-56x1-philips-91772A0861
2-56 x 1" philips screw
4
2 SCREW INSULATOR10SC004025
Nylon tension limiter
4
3
70700S
spring 4
4MCW6
0
Water-block 1
5 1-4-NPSMx3-8-barb 1/4" NPSM X 3/8" Barb fitting 2
6 MCW60-HOLD-DOWN-PLATE
Hold-down plate
1
7 CROSS-bracket-NV40
Stiffening brace
1
8
VGA Adapter
1
1
2
3
5
8
7
6
4
• Remove the existing heatsink
• Clean off the GPU with a degreaser, and spread some of the included thermal compound over it.
• Install the MCW60 onto the GPU
• Temporarily fasten two screws #1 in diagonal without their springs and washer. This will conveniently align stiffening brace
#7 with hold-down plate #6.
• Then Install the other two screws with their springs and washer as shown in this schematic, and tighten them half-way.
• Remove the first two screws you used as guides, and re-install them with their springs and washer then tighten half-way.
• Complete tightening of all four screw-spring assemblies in a cross pattern.
• Installation of the water-block is now complete