Owner manual

Copyright Swiftech 2006 - All rights reserved - Last revision date: 05-09-06 - One or more Patents Pending
Rouchon Industries, Inc., dba Swiftech - 1703 E. 28th Street, Signal Hill, CA 90755 - Tel. [phone] - Fax [phone] -
E Mail: [e-mail] - URL: http://www.swiftnets.com - Information subject to change without notice
Installation with nVidia GeForce 6800 to 7900 series
& ATI X1800 and above
(four mounting holes)
ITEM NO. PART NUMBER DESCRIPTION QTY
.
1MCW60 WATER-BLOCK 1
2 1-4-NPSMx3-8-barb 1/4" NPSM X 3/8" Barb fitting 2
3 MCW60-HDP-R2 MCW60 HOLD-DOWN PLATE R2 1
4 MCW60-CB-R2 MCW60 CROSS-BRACKET R2 1
5 MCW60-2-56-PFH-CS 2-56 CUSTOM SCREW 4
6 REFERENCE VGA ADAPTER 1
1
3
2
6
4
5
• Remove the existing heatsink
• Clean off the GPU with a degreaser, and spread some of the included thermal compound over it.
• Position the MCW60 over the GPU, aligning the 4 feet of the hold-down plate to the circuit board thru-holes
• Insert screws #5 thru cross-bracket #4, thru the circuit board, and fasten them into the legs of hold-down plate #3,
tightening the screws gradually and in a cross pattern.
• Installation of the water-block is now complete