User Manual

Rouchon Industries, Inc., dba Swiftech – 3400 Industry ave, suite 104, CA 90712 – Tel. 562-595-8009 – Fax 562-595-8769

E Mail: Swiftech @swiftech.com – URL: http://www.swiftech.com

GT200 Adapter plate for MCW60

nstallation Guide

Item # Part # Description Quantity

1 2-56x7/8" Philips Screw 4

2 MCW60-GT200 HDP Hold-down Plate 1

3 6-32x3/8 socket Screws n/a

4 15TSB056B Tapped nylon spacer 4

5 GT200 VGA Graphics Card n/a

6 GT200 VGA Back plate n/a

7 77706 2-56 Thumb nut 4

Tolerance washer

1. Remove the existing hold-down plate from the MCW60 by loosening the (4) socket screws #3, and

replace it with the provided GT200 adapter plate.

2. Insert the (4) provided Philips screws #1 into the mounting holes of the hold-down plate, and fasten

them to the plate with the (4) provided threaded nylon spacers #4

3. Clean the GPU surface from old thermal compound with alcohol or an electronics degreaser, and

apply the equivalent of a little mound of the provided Arctic Céramique Thermal compound

Information subject to change without notice

PAGE 1
GT200 Adapter plate for MCW60 Installation Guide Item # 1 Part # 2-56x7/8" Philips Description Screw Quantity 4 2 3 4 5 6 MCW60-GT200 HDP 6-32x3/8 socket 15TSB056B GT200 VGA GT200 VGA Hold-down Plate Screws Tapped nylon spacer Graphics Card Back plate 1 n/a 4 n/a n/a 7 77706 2-56 Thumb nut 4 Tolerance washer 8 3 4 1 2 8 4 5 6 7 1. Remove the existing hold-down plate from the MCW60 by loosening the (4) socket screws #3, and replace it with the provided GT200 adapter plate. 2.
PAGE 2
4. Place the MCW60 onto the CPU, the stock back-plate to the back of the card, and tighten all (4) thumb nuts #7 incrementally and in a cross pattern. The installation is finished. Always test your components for leaks prior to powering-up the motherboard. Acceptable alternative installations: 1. Using the original back-plate is optional 2.