User Manual

This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in

damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their

installation. The following instructions are subject to change without notice. Please visit our web site at

www.swiftnets.com for

updates.

ITEM

NO.

PART NUMBER DESCRIPTION QTY.

1 MCRES-MICRO Reservoir 1

1-4“ NPSM x 3-8“ and 1-2“barb

Barb fitting

2 pairs

each

3 O-RING-9557K473 Barb fitting O-Ring 2

4 pg7-o-ring

Fill-cap o-ring

5 pg7-plug Pg7 Fill-cap 1

6 MOUNTING HARDWARE 3

90272A152-6-32x0500philips 6-32 x 7/8" (22mm) Philips screw 1

90760A007

6-32 Nut 1

washer-91007A614

Lock Washer

WASHER-RUBBER-437X150X092 Rubber Washer 1

7 panel 1

Figure 1

Rouchon Industries, Inc., dba Swiftech – 1703 E. 28

Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail:

Swiftech@swiftnets.com – URL: http://www.swiftnets.com - Information subject to change without notice

PAGE 1
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.swiftnets.com for updates. ITEM NO. PART NUMBER DESCRIPTION QTY.
PAGE 2
Product Description The MCRES-MICRO is a small form factor reservoir designed for liquid-cooled personal computers. The device features two 1/4” NPSM threaded ports and a Pg7 fill-port and is shipped with two sets of hose barbs, 3/8” and ½” to accommodate most high-flow systems. The port usage is defined as follows: Upper port: “In from system” shown in figure 1 is the return line from the system Lower port: “Out to pump inlet” shown in figure 1 should be connected to the pump inlet.
PAGE 3
MCRes Micro Bracketry installation and examples 6 7 5 ITEM NO. PART NUMBER 1 2 BCKT1 BCKT2 90272A146-6-32x3-8-philips 3 4 5 DESCRIPTION QTY . 1 "L" bracket "U" bracket 2 6-32 x 3/8” Philips screw 6-32 x 1 3/4" Philips screw 6-32 Nut w/teeth washer 3 2 3 6 FW150X437X092 Rubber Washer 437X150X092 2 7 93286A041-WASHER zinc plated washer 5 91772A158-6-32X1.75 90760A007 Note 1: rubber washer 6 should be inserted between either side of the reservoir ear and the U bracket 2.