User Manual



Installation guide
Parts QTY PARTS QTY
MCW6000™ water-block 1 Spring loaded screw assemblies 2
Worm drive clamps 2 Sk8 hold-down plate 1
NOTE TO USERS: SOME OPTERON MOTHERBOARDS (MSI BRAND) DO NOT USE AMD STANDARD RETENTION MECHANISM. PLEASE
USE INTEL PENTIUM 4 (SOCKET 478) HOLD-DOWN PLATE & CLIPS INSTEAD WITH THESE MOTHERBOARDS.
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to
your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their installation. The
following instructions are subject to change without notice. Please visit our web site at www.swiftnets.com
for updates.
4
5
6
7
8
2
1
3
3
ITEM NO. QTY. PART NO. DESCRIPTION
1 1 MCW6000-R2 MCW6000 flat base water-block
2 1 S754-RETENTION-r2 SK8 hold-down plate for AMD K8
3 1 K8_Motherboard AMD K8 (Athlon 64 & Opteron) motherboard+processor assy.
1 counter-plate
1 motherboard
1 retention-frame
4 2 91772A158-6-32X1.75 6-32 x 1 3/4" philips screw
5 2 93286A041-WASHER zinc plated washer
62885 spring
7 2 spacer-205x140x773 tension limiter
8 2 6-32 nylon retaining washer 6-32 nylon retaining washer
Figure 5
Copyright Swiftech 2004 – All rights reserved – Last revision date: 11-23-04
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. [phone] – Fax [phone] - E Mail:
[e-mail] – URL: http://www.swiftnets.com
- Information subject to change without notice Page 31 of 38
1. PREPARING YOUR MOTHERBOARD
 Remove the existing heat sink

Carefully clean the CPU.