User Manual

Installation guide
Parts list
Parts QTY PARTS QTY
MCW6000-P™ water-block 1 Retention clips 2
Worm drive clamps 2 SP4 hold-down plate 1
1. PREPARING YOUR MOTHERBOARD
 Remove the existing heat sink

Carefully clean the CPU.
 Lightly coat the CPU with the included Arctic Céramique thermal compound. Application will vary depending on the type of processor. We
recommend visiting http://www.arcticsilver.com for detailed instructions.
2. WATER-BLOCK ORIENTATION
For ease of operations during bleeding, the outlet should always be at the highest point (while system is standing upright):
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may
result in damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these
products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at
www.swiftnets.com
for updates.
b
ITEM NO. QTY. PART NO. DESCRIPTION
1 1 S478 Intel Pentium 4 socket 478 motherboard and processor
2 1 MCW6000-P-with-bracket MCW6000-P water-block assembly
a 1 MCW6000-FLAT MCW6000 waterblock flat base
1 SP4-Bckt SP4 Hold-down plate for Intel Pentium 4 and Xeon
3 2 SC478 Pentium 4 spring clip
3
1
INLET
DISCHARGE
Copyright Swiftech 2004 – All rights reserved – Last revision date: 11-23-04
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. [phone] – Fax [phone] - E Mail:
[e-mail] – URL: http://www.swiftnets.com
- Information subject to change without notice Page 19 of 38