User Manual

Parts list
Parts QTY PARTS QTY
MCB-120™ Housing assembly 1 Coolsleeves™ 20” (*)
Retention hardware (screws, etc.) 1 PCI Pass-Thru kit 1 (*)
½” tubing 2’ (*) Worm drive clamps 4 (*)
(*) Only included with complete kit
1. PCI PASS-THRU KIT INSTALLATION
o Insert the PCI bracket into an available opening, and secure it to the chassis.
o Insert your fan electrical connector through the slotted hole of the PCI bracket now. Only 3-pin
connectors (the type that connect to the motherboard) are small enough to pass through the slotted hole.
4-pin Molex connectors (the type that connect to your power supply) will require that the terminals be
removed from the Molex housing first.
o From inside of the chassis, insert the pass-thru adapters through each hole of the PCI bracket. The
threaded portion of the adapters should be exposed outside of the case.
o Screw the nuts to the adapters. The nuts are designed to slightly overlap the edges of the PCI chassis
opening, to provide a more secure installation.
Copyright Swiftech 2004 – All rights reserved – Last revision date: 11-23-04
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. [phone] – Fax [phone] - E Mail:
[e-mail] – URL: http://www.swiftnets.com
- Information subject to change without notice Page 17 of 38