Owner's manual

Copyright Swiftech 2004 – All rights reserved – Last revision date: 11-23-04
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. [phone] – Fax [phone] - E Mail:
[e-mail] – URL: http://www.swiftnets.com
A
SSEMBLY USING PLASTIC
FRAME AND SPRING CLIPS
INCLUDED WITH MOTHERBOARD
16 PART NO. DESCRIPTION
1DUAL-XEON-BOARD Motherboard
2 RETENTION Plastic retention frame, included with motherboard
3 XEON-CLIP Xeon clip included with motherboard
4 MCW6000-P-with-bracket MCW6000-P water-block assembly
a MCW6000-FLAT MCW6000 waterblock flat base
b SP4-Bckt Hold-down plate for Intel Pentium 4 and Xeon
3
4b
4a
2
1
FLUID INLET
FLUID DISCHARGE
Figure 2
1. Preparing your Motherboard:

Remove the existing heat sink

Carefully clean the CPU.

Lightly coat the CPU with the included Arctic Céramique thermal compound. Application will vary depending on the type of
processor. We recommend visiting http://www.arcticsilver.com for detailed instructions.
2. Water-block orientation:
For ease of operations during the filling and bleeding procedures, the outlet should always be at the highest point (while the computer
system is standing upright):
3. Water-block installation:
The MCW6000-PX can be installed using two different methods (also see figure 1 and 2):
- Information subject to change without notice Page 27 of 41