Owner manual

Copyright Swiftech 2006 – All rights reserved – Last revision date: 08-30-06 - Information subject to change without notice – URL: http://www.swiftnets.com
Rouchon Industries, Inc., dba Swiftech – 3700 Industry Avenue, Suite 104, Lakewood, CA 90712 – Toll free (US): 866-857-9438 – Fax [phone] - E Mail:
[e-mail]
PAGE 26 of 36
 Installation with nVidia GeForce 6800 to 7900 series & ATI X1800 and above (four mounting holes)
ITEM NO. PART NUMBER DESCRIPTION QTY
.
1 MCW60 WATER-BLOCK 1
2 1-4-NPSMx3-8-barb 1/4" NPSM X 3/8" Barb fitting 2
3 MCW60-HDP-R2 MCW60 HOLD-DOWN PLATE R2 1
4 MCW60-CB-R2 MCW60 CROSS-BRACKET R2 1
5 MCW60-2-56-PFH-CS 2-56 CUSTOM SCREW 4
6 REFERENCE VGA ADAPTER 1
1
3
2
6
4
5
· Remove the existing heatsink
· Clean off the GPU with a degreaser, and spread some of the included thermal compound over it.
· Position the MCW60 over the GPU, aligning the 4 feet of the hold-down plate to the circuit board thru-holes
· Insert screws #5 thru cross-bracket #4, thru the circuit board, and fasten them into the legs of hold-down plate #3,
tightening the screws gradually and in a cross pattern.
· Installation of the water-block is now complete