Owner manual

Copyright Swiftech 2006 – All rights reserved – Last revision date: 08-30-06 - Information subject to change without notice – URL: http://www.swiftnets.com
Rouchon Industries, Inc., dba Swiftech – 3700 Industry Avenue, Suite 104, Lakewood, CA 90712 – Toll free (US): 866-857-9438 – Fax [phone] - E Mail:
[e-mail]
PAGE 25 of 36
 Installation with ATI Radeon (2 mounting holes)
ITEM
PART NUMBER
DESCRIPTION
QTY
.
1 mcw60-housing-rev2 1
2
MCW60 BASE PLATE 1
3 O-RING_3-32 Body o-ring 1
4
1-4-NPSMx3-8-barb
1/4" NPSM X 3/8" Barb fitting
2
5 O-RING-9557K473 1-4'" NPSM barb fitting O-Ring 2
6 92196A146 6-32 x 5/8 socket screw
4
7 stiffening-bar 1
8 4-40x1-25-philips-91400A124 4-40 x 1.25 philips screw 2
9
70700S
spring
2
10 X800-XT 1
11
13ME028
Nylon metric flat washer
2
12 4-40-acorn-nut Nylon Nut 4-40 - 0500440CN 2
13 washer-240x140x0038 2
14
SCREW INSULATOR10SC004025 2
15 LOCK-WASHER#6 #6 lock washer x 0.030" 4
16 MCW60-HDP-R2 WCW60 HOLD-DOWN PLATE R2
1
17 - Discard
12
14
9
13
6
15
1
3
2
11
7
8
5
· Remove the existing heatsink
· Clean off the GPU with a degreaser, and spread some of the included thermal compound over it.
· Install the MCW60 onto the GPU
· Install screws #8, back-plate #7 and nylon spacers #11 thru the circuit board and the MCW60 water-block.
· Install washers #13, springs #9, compression limiter #9 and acorn nut #12, then gradually and alternatively fasten acorn nuts
(#12) until they bottom out.
· Installation of the water-block is now complete.