Use and Care Manual

7
Connect the water supply to the filter receiver
 The input end of the filter receiver assembly uses a push-in type tubing. Connect hose to the following
push-in connection instructions. (Fig.7)
 Connect the other end of supply line hose to the cold water supply (Fig.8).
Install the filter
 The filter can be installed after ensuring all connection on the supply and faucet end are secure.
 Insert the filter cartridge in the receiver assembly and turn it towards right until the filter stops.
Cartridge replacement instructions
 To ensure optimum filter performance the filter cartridge should be replaced every six months.
 Hold the filter and turn it towards the left. Gently pull out the filter from the assembly when it
becomes loose. (Note: keep a towel in case of a water spill.)
 Insert the new filter in the receiver and turn it towards right until it stops.
 Run the water to flush 10-15 gallons through the system before you start using.
Fig. 7 inserting the plastic hose into the push-in
type connection
Fig. 8 connecting cold water supply line to
receiver refer to Fig.1