Use and Care Manual

Connect faucet hose line to filter receiver

 Connect the faucet hose end to the output end of the filter receiver assembly. The output end uses a

brass fitting (

NPT x

NPT male connector).

 Set the hex nut on the faucet with threads facing tube end and 3/8” ferrule with the tapered end

down. Insert the 3/8” tube insert into the tube (Fig. 4). Use a wrench to connect faucet hose to the

output end of the receiver end. Pull the tube to ensure the connection is firmly secure. (Note: loose

connection may lead to leakage. The correct orientation of sleeve, nut and ring is critical to

prevention of leakage).

Push-in tubing connection

 Connect Push-in type tubing: For attaching the hose to the push-in tube type connection insert the

hose past the O-ring until it hits a backstop. Try pulling the hose to ensure the connection is secure

(Fig. 5).

 Release Push-in type tubing: Push the collet (Fig. 6) on the adapter for releasing the tubing. With the

collet pushed in pull out the hose from the connection.

Figure 3 Turn off and disconnect the

existing cold line using wrench

Figure 4. Inserting the metal sleeve in the tube is

necessary when connecting the plastic hose to a

metal fitting (Refer to Fig. 1)

Fig. 5 inserting the plastic hose into the push-

in type connection

Fig. 6 Hose can be removed by pressing the

collet and pulling the tube out keep the collet

pressed