Datasheet

English version

Rear view

1. LAN ports 1, 2, 3 and 4 for connecting computers by means of an RJ-45 UTP Ethernet network cable.

2. WAN port for connecting a modem by means of a RJ-45 UTP Ethernet network cable.

3. Reset button to return to the factory settings.

4. Power connector for connecting the power adaptor.

Connecting the Sweex Broadband Router

1. Connect the power adaptor (included) to the rear of the router and the mains socket. The light next to “Power” is lit. In the event the LED is not

lit, check the connections of the power adaptor to the router and the mains socket.

2. Switch on the computer and connect it to the rear of the modem using a network cable (RJ-45 UTP). You can select any of the ports 1, 2, 3

and 4. The corresponding light at the front will be lit. In the event the light fails to light up, check whether the network cable is properly

connected to the computer and the router.

3. Switch on the modem* again. Note: Here we do not refer to the Sweex router. Connect the modem to the rear of the router using a network

cable (RJ-45 UTP). Do this via the WAN port The WAN light at the front of the router will light up. In the event the light fails to light up, check

whether the network cable is properly connected to the router and the modem.

* In order to use the Sweex Broadband Router you need an active Internet connection, which is established through a modem. This modem is

usually supplied by the provider.

1 2 3 4 WAN RESET AC 9V