Use and Care Manual

ASSEMBLY INSTRUCTIONS
REMINDER
DANGER indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
DANGER
Failure to comply with the precautions and instructions
provided with this reector can result in death, serious
bodily injury and property loss or damage from hazards of
re, explosion, burn, asphyxiation, and/or carbon monoxide
poisoning.
Only persons who can understand and follow the
instructions should use or service this heater.
DANGER
WARNING indicates an imminently hazardous situation
which, if not avoided, could result in death or serious
injury.
WARNING
General Safety Information
This manual contains important information about the assembly, operation and maintenance of this reector. General safety
information is presented in these rst few pages and is also located throughout the manual.
Keep this manual for future reference and to educate new users of this product. This manual should be read in conjunction with the
labeling on the product.
Safety precautions are essential when any mechanical or propane fueled equipment is involved. These precautions are necessary
when using, storing, and servicing. Using this equipment with the respect and caution demanded will reduce the possibilities of
personal injury or property damage.
The following symbols shown below are used extensively throughout this manual. Always heed these precautions as they are essential
when using any mechanical or fueled equipment.
Note: Do not install more than one reector on a single heater and remove protective lm before use. Follow all safety and
assembly instructions before using this product. End user and/or operator assumes liability for all risk and/or damage to
property and/or persons that may result from use and/or handling of this product and/or improper installation.
After following proper assembly instructions, please review the operational checklist on the last page prior to use. This will provide a thorough
check before you being to enjoy the reector and remain safe during and after each use.
Please follow all safety instructions that came with your unit.
Improper installation , adjustment, alteration, service or
maintenance can cause injury or property damage. Read
the instructions thoroughly before installing or servicing
this equipment.
WARNING
CAUTION indicates an imminently hazardous situation
which, if not avoided, may result in minor or moderate
personal injury, or property damage.
CAUTION
WARNING: For Outdoor Use Only
We cannot foresee every use which may be made of our
reectors. Check your local re safety authority if you
have questions about the heater or reector use.
Other standards govern the use of fuel gases and heat
producing products for specic uses. Your local authorities
can advise you about these.
If no local codes exist, follow National Fuel Gas Code,
ANSI Z223.1. In Canada, installation must conform to local
codes. If no local codes exist, follow the current National
standards of CANADA CAN/CGA-B 149.2.
WARNING
WARNING
1. If you smell gas:
a. Shut o gas to the propane.
b. Extinguish open ame.
c. If odor continues, immediately call your gas supplier.
2. Do not handle this product while hot.
3. Remove the product from any heater when not in use.
4. Remove in windy, stormy, or other inclement weather.
5. Never use in unfavorable conditions.
6. Do not use in windy weather. The heat reector can
cause the heater to tip over in as little as 5 mph winds.
7. Do not use if winds exceed 5 mph.
• Never leave heater or reector unattended when hot or
in use.
• Keep out of reach of children.
• Do not expose this product to ame or direct heat.
BURN HAZARD
WARNING
• Heater will be hot after use. Handle with extreme care.
• Do not cross under or stay under or near the vicinity of
this product while installed.
• Do not use if safe operating temperatures of heater
and/or surrounding objects are exceeded.
• Maintain a minimum distance of at least 8 inches between
any part of this product and the source of heat.
• Do not stick any part of your body or any objects in
between the reector and the heating unit while the
heating unit is on. This area will be extremely hot and you
should approach with extreme caution.
FOR YOUR SAFETY
WARNING
Please read all safety information and assembly instructions in the following pages before use. By using this product, you acknowledge
that you have read and agreed to the safety instructions within this pamphlet and found online. You also agree to hold Sweet Heat LLC
harmless in the event you do not follow the safety instructions.
2A. START WITH THE MIDDLE CLAMP. PLACE
MIDDLE CLAMP OPPOSITE TO HEATER
CONTROLS.
2B. TIGHTEN THUMB SCREW UNTIL SNUG AND
REFLECTOR FEELS SECURELY ATTACHED TO
HEATER.
WARNING:
HEATER CONTROLS
MUST FACE AWAY
FROM
SWEET HEAT
REFLECTOR
TIGHTEN
MIDDLE CLAMP
3B. TIGHTEN THUMB SCREWS UNTIL SNUG AND
REFLECTOR FEELS SECURELY ATTACHED TO
HEATER.
(NOTE: INSPECT THUMB SCREWS OFTEN, TIGHTEN AS NEEDED AND
DO NOT TOUCH OR HANDLE WHILE HOT)
3A. AFTER SECURING THE MIDDLE CLAMP,
PUSH EACH OF THE SIDES TOWARD THE
HEATER AND TIGHTEN EACH THUMB SCREW
SNUGGLY TO SECURE REFLECTOR TO HEATER.
1A. PREPARE FOR INSTALLATION BY MAKING
SURE THE HEATER IS OFF AND COOL PRIOR TO
ASSEMBLY.
1B. TURN THUMB SCREWS ON ALL THREE
CLAMPS TO MAXIMIZE GAP.
WARNING: HOT
(NOTE: DO NOT PLACE
HEATER UNDER ANYTHING)
PUSH ENDS
TOWARD HEATER.
THEN TIGHTEN CLAMPS
WARNING: OVER TIGHTENING
THE THUMBSCREW MAY DENT
THE HEATER.
MAXIMIZE
GAP
THUMB SCREW
WITH SWEET HEAT
MORE HEAT WILL FLOW
IN THIS DIRECTION