User's Manual

6 Instructions for the safe Installation and use of
the Tracker
The Tracker is intended for integration with a finished product. The integrator of the Tracker is
required to connect an appropriate antenna, along with a USB-C cable to charge the Tracker.
To ensure that the Tracker is correctly installed the following general instructions (sub-section
6.1) are provided for the installer:
The integrator will be required to supply the end user of the integrated product, incorporating the
Tracker, with operating instructions and any other information relating to the maintenance and
safety of the equipment (sub-section 5.2).
The power supply used to charge the Tracker must be checked to ensure it meets the
requirements of sub-section 4.1 of this document.
The Tracker shall not be located in close proximity to sources of extreme temperature which will
cause it to be operated outside of its temperature specification (-10ºC to +45ºC).
The Tracker shall not be operated without an appropriate antenna connected to its antenna
connector via a suitable 50 Ohm SMA connector.
The Tracker may be body worn, or mounted on other equipment. When body worn, only the
Swarm 8.5” Coiled Antenna may be used.
19