User's Manual

4.3.3.2 Disabling Bluetooth Interface

To disable the Bluetooth interface, issue the following command followed be a reset of the

Tracker:

$config bt disabled

To reset the Tracker, issue the following command:

$reset

4.3.3.3 Sending and receiving commands through Bluetooth Interface

After enabling the Bluetooth interface on the Tracker, the Tracker will broadcast it’s address as:

Swarm-XXXXXX (Where XXXXXX [ex: 033FEA] are the last 6 digits of the Tracker’s bluetooth

MAC address)

If your device is connected to the Tracker through its wired serial port, the Bluetooth pin will

display as:

BT PIN: Please compare the numeric value: YYYYYY (where YYYYYY [ex: 123876] is the

Bluetooth PIN)

After pairing, a serial connection can be opened over the bluetooth connection.