Product Manual

Tile status
Status messages indicate that the Tile has booted and acquired date/time and position
information from the GPS network. Error and debug messages are also sent as status
messages. Tile status messages cannot be disabled.
$TILE <msg>,[<data>]*xx
Parameter
Description
msg
BOOT Tile has booted and is ready to receive commands
DATETIME Tile has acquired date/time from the GPS network
POSITION Tile has acquired position from a valid 3D fix from the GPS
network
ERROR Error message (typically text)
DEBUG Debug message (typically text)
data
RUNNING The Tile is running and can now accept commands
POWERON The Tile has detected power applied to it
UPDATED A firmware update was performed
FAULT A firmware crash occurred and the Tile restarted
Notes:
A data message follows the BOOT message to indicate the reason for the startup. The
DATETIME will be sent once the GPS has acquired the date/time from the GPS network. The
POSITION will be sent once a valid 3D fix has been acquired from the GPS network. The
POSITION message will typically occur before the DATETIME message. Depending on the GPS
signal quality, it may take several minutes before the DATETIME or POSITION message is
emitted.
29