User's Guide
Table Of Contents
- 1. Introduction
- 2. Technical Data
- 3. Block Diagram
- 4. Connector Configuration
- 5. Test Points
- 6. LEDs
- 7. Schematic
- 8. Dimensions
- 9. Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v01
- 9.1. List of applicable FCC / ISED rules
- 9.2. Specific operational use conditions
- 9.3. Limited module procedures
- 9.4. Trace antenna designs
- 9.5. RF exposure considerations
- 9.6. Antennas
- 9.7. Label and compliance information
- 9.8. Information on test modes and additional testing requirements
- 9.9. Additional testing, Part 15 Subpart B disclaimer
- 9.10. Host Product Labelling Requirements
- 10. Disclaimer
- 11. References
NA-20-0386-0006-1.5 Inpixon Swarm Chirp V3 Dev Board User Guide
Inpixon_UG_Swarm_Chirp_V3_Dev_Board_1.5.docx 25
© Inpixon. All rights reserved. | www.inpixon.com FRM0008-A1
9.10. Host Product Labelling Requirements
9.10.1. FCC
The host product shall be properly labelled to identify the modules within the host product.
The FCC certification label of a module shall be clearly visible at all times when installed in the host product; otherwise,
the host product must be labelled to display the FCC certification number for the module, preceded by the word
"contains" or similar wording expressing the same meaning, as follows:
Contains FCC: SIFSBLEV3DKPLUS
9.10.2. ISED
The host product shall be properly labelled to identify the modules within the host product.
The ISED certification label of a module shall be clearly visible at all times when installed in the host product;
otherwise, the host product must be labelled to display the ISED certification number for the module, preceded by
the word "contains" or similar wording expressing the same meaning, as follows:
Contains IC: 7654A-SBLEV3DKPLS