User's Guide
Table Of Contents
- 1. Introduction
- 2. Technical Data
- 3. Block Diagram
- 4. Connector Configuration
- 5. Test Points
- 6. LEDs
- 7. Schematic
- 8. Dimensions
- 9. Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v01
- 9.1. List of applicable FCC / ISED rules
- 9.2. Specific operational use conditions
- 9.3. Limited module procedures
- 9.4. Trace antenna designs
- 9.5. RF exposure considerations
- 9.6. Antennas
- 9.7. Label and compliance information
- 9.8. Information on test modes and additional testing requirements
- 9.9. Additional testing, Part 15 Subpart B disclaimer
- 9.10. Host Product Labelling Requirements
- 10. Disclaimer
- 11. References
NA-20-0386-0006-1.5 Inpixon Swarm Chirp V3 Dev Board User Guide
Inpixon_UG_Swarm_Chirp_V3_Dev_Board_1.5.docx 24
© Inpixon. All rights reserved. | www.inpixon.com FRM0008-A1
9.8. Information on test modes and additional testing requirements
The final host product shall comply to the CE, FCC or ISED rules mentioned in section 9.1. For this, the host product
manufacturer must adapt the TX output power so that the radiated power at the product antenna never exceeds +20
dBm. AN0521 [3] which can be requested at our support [4]. explains how to adapt the TX output power of the Inpixon
Swarm Chirp V3 module accordingly. The setup requires a computer connected directly or indirectly to the swarm
bee module USART to allow control of it via the API. The measurement shall be done in an anechoic chamber or in a
space without multipath and unwanted external RF signals causing erroneous measurement of the host product
under test.
Figure 9-2: Test setup
Definitions:
P
1
: Radiated power of the host product antenna
P
2
: Gain of the receiving power meter antenna for the given RF band
P
air
: Free space propagation loss
P
loss
: Total attenuation caused by all cables and connectors
P
meas
: Measured RF power from the power meter for the given frequency band
9.9. Additional testing, Part 15 Subpart B disclaimer
This Inpixon Swarm Chirp V3 Dev Boards comply to the FCC rules stated in section 9.1 and doesn’t require additional
testing according to part 15 subpart B. The host product manufacturer is responsible for compliance to any
other FCC rules that apply to the host not covered by the modular transmitter grant of certification.