User's Guide

Table Of Contents

NA-20-0386-0006-1.5 Inpixon Swarm Chirp V3 Dev Board User Guide

Inpixon_UG_Swarm_Chirp_V3_Dev_Board_1.5.docx 22

9. Integration instructions for host product manufacturers

according to KDB 996369 D03 OEM Manual v01

9.1. List of applicable FCC / ISED rules

FCC:

ISED:

47CFR-§15.212

RSS-100

47CFR-§ 15.203

RSS-102

47CFR-§ 15.247

RSS-247

47CFR-§ 15.249

RSS-GEN

9.2. Specific operational use conditions

Use case scenarios must conform to FCC 10.5/RF and ISED exposure considerations. In the case of this board, it must

be at least 20 cm away from a human body.

9.3. Limited module procedures

Not applicable

9.4. Trace antenna designs

Not applicable. The supplied antenna (PSKN3-24/55S) is a dipole one.

9.5. RF exposure considerations

RF exposure requirements are fulfilled for mobile configuration. The installation of the module is restricted to mobile

host devices what is clearly stated in the installation instruction of the user manual.

For portable applications, OEM integrators need their own SAR evaluation and thus an own FCC ID.

9.6. Antennas

Each swarm bee LE module is calibrated during production not to exceed +17 dBm at the RF port. However, if the

host product manufacturer wants to take another antenna, he shall take the used antenna gain into consideration

and adapt the radiated power so that his product does not exceed +20 dBm at the antenna. This shall be done as

explained in section 9.8.