User's Guide
Table Of Contents
- 1. Introduction
- 2. Technical Data
- 3. Block Diagram
- 4. Connector Configuration
- 5. Test Points
- 6. LEDs
- 7. Schematic
- 8. Dimensions
- 9. Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v01
- 9.1. List of applicable FCC / ISED rules
- 9.2. Specific operational use conditions
- 9.3. Limited module procedures
- 9.4. Trace antenna designs
- 9.5. RF exposure considerations
- 9.6. Antennas
- 9.7. Label and compliance information
- 9.8. Information on test modes and additional testing requirements
- 9.9. Additional testing, Part 15 Subpart B disclaimer
- 9.10. Host Product Labelling Requirements
- 10. Disclaimer
- 11. References
NA-20-0386-0006-1.5 Inpixon Swarm Chirp V3 Dev Board User Guide
Inpixon_UG_Swarm_Chirp_V3_Dev_Board_1.5.docx 18
© Inpixon. All rights reserved. | www.inpixon.com FRM0008-A1
6. LEDs
Several LEDs have been placed to display the status of particular functions.
Figure 6-1: LEDs position
Table 6-1: LEDs assignment
TP No.
Description
Function
Comments
LED2
TX_ON
On: RF transmission
Luminescence 50 ms
LED3
PWR Host
External Power connected
PWR Host takes precedence
on PWR USB
LED4
PWR USB
USB Power connected
LED6
USART_RX
Status of serial RX line
LED7
USART_TX
Status of serial TX line
LED8
GPIO
If connected to jumper matrix status of the connected GPIO
High: On / Low: Off