User's Guide
Table Of Contents
- 1. Introduction
- 2. Technical Data
- 3. Block Diagram
- 4. Connector Configuration
- 5. Test Points
- 6. LEDs
- 7. Schematic
- 8. Dimensions
- 9. Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v01
- 9.1. List of applicable FCC / ISED rules
- 9.2. Specific operational use conditions
- 9.3. Limited module procedures
- 9.4. Trace antenna designs
- 9.5. RF exposure considerations
- 9.6. Antennas
- 9.7. Label and compliance information
- 9.8. Information on test modes and additional testing requirements
- 9.9. Additional testing, Part 15 Subpart B disclaimer
- 9.10. Host Product Labelling Requirements
- 10. Disclaimer
- 11. References
NA-20-0386-0006-1.5 Inpixon Swarm Chirp V3 Dev Board User Guide
Inpixon_UG_Swarm_Chirp_V3_Dev_Board_1.5.docx 17
© Inpixon. All rights reserved. | www.inpixon.com FRM0008-A1
Table 5-2: Description of operating modes shown in Figure 5-2
State
Description
1
Wakeup after nap mode
2
Switching on the DC/DC converter for supplying the RF power amplifier and
nanoLOC Initialization of nanoLOC
3
Frequency calibration of nanoLOC
4
Initialization of the MEMS sensor
5
Transmitting Broadcast ID
6
Receiving Window
7
Shut down to nap mode