&y Swan www.swanstone.
Safety Guidelines The Swan Assurance if our product is properly Installed and maintained, as stated in these instructions, it will not leak. Remember = Safety First IMPORTANT NOTICE l The Swan Corporation, the makers of the Swan products, cannot anticipate every possible circumstance that might involve a potential hazard during the installation of our product{s). The warnings and instructions in this installation guide are, therefore, not all-inclusive.
Safety Guidelines General Information Cutting Hazard The installation of the Swan Corporation product may require using power tools. Keep hands away from the cutting edge of any tool used in the installation of our product. Placing fingers in or around the cutting blades could result in serious personal injury. Sharp Edge Hazard A After citing the edge of a Swan Corporation panel, it can be sharp, Wear protective gloves (o prevent personal injury.
General information Installation Procedure Unpack Carton O Use care when opening the hax sa that you do not damage the panels. Q This product is shipped to you or your retail center naffer careful inspection. After purchasing the kit, carefully unpack and inspect the product far any shipping damage that may have occurred, If damage is found, report it immediately to the store of purchase.
Installation Procedure 3. Measure, mark, and cut the left and right vertical panels to window jam depth measurement (B). Trial fit all three panels. If necessary, trim height (C) of the vertical panels to line up with the top edge of the tub or shower wall panels. Sand the cut edges with medium grit sandpaper, 4. Clean the back of the panel with denatured alcohol. & IMPORTANT NOTICE Do not use all-based cleaners, such as mineral spirits, to clean the panels.
Cleaning and Maintenance Warranty Care and Cleaning Swan Corporation high gloss products are stain and abrasion resistant; however, the finish requires reasonable care, IMPORTANT NOTICE Because cleaning products change over time, always check the manufacturer's Instructions to make sure it Is compatible with fiberglass reinforced polyester, DO NOT use a cleaner the label indicates it should not be used on fiberglass reinforced polyester.
Ave these Installation Instructions for future reference. They provide important information on cleaning and maintenance of Swan Corporation products. &V Swan www.theswancarp.com Form # 250.08.
