Installation Instructions

Attaching Shower Doors and Accessories
1. Follow the mounting instructions that come with each
accessory.
2. Drill pilot holes, where fasteners pass through the wall
panels, slightly larger than the fastener.
3. If anchors are being used, drill the hole in the panel large
enough for the head of the anchor to t through the panel
and the structural wall behind it.
4. Use 100% clear silicone to seal any holes or joints between
the accessory and the wall panel.
Care and Cleaning
Swan Corporation Veritek products are stain and abrasion
resistant; however, the nish requires reasonable care.
Because cleaning products change over time, always check
the manufacturer’s instructions to make sure it is compatible
with solid surface acrylic or with berglass reinforced polyester.
DO NOT use a cleaner if the label indicates it should not be
used on solid surface acrylics or berglass reinforced polyester.
DO NOT use spray-on cleaners that require daily use without
immediately rinsing with water to stop the chemical cleaning
reaction because damage will result and void the warranty.
Day-To-Day Cleanup
Simply wipe the surfaces with a clean towel to remove
watermarks and residues. All Swanstone products can be
cleaned with warm water, a soft cloth, and normal household
detergents or cleansers, such as Fantastic, Formula 409,
Clorox Clean-up, Handy Andy, Mr. Clean, Dow Scrubbing
Bubbles, Lysol Foaming Tub and Tile Cleaner, Top Job,
or Lestoil. Always rinse off cleaners within ve minutes of
application.
Occasional scrubbing with household abrasive cleaners
ensures that the original luster is maintained.
Caulking Joints
Inspect caulking joints monthly for damage or any signs of
separation from the mating surface. Cracks in the caulking
will allow water to leak into the surrounding surfaces. Reapply
caulking to any joint showing signs of wear or cracking. Failure
to inspect and repair caulking joints will void the warranty.
800-325-7008 17 Swan
Installation Procedure Maintenance & Cleaning