Installation Instructions

1. Place the panel on top of the tub and slide it against the
back wall panel.
2. Scribe (mark) the panel, as shown. If the panel is wider than
the wall, take this width into consideration when scribing the
panel.
Flat Panel
Square Tile or Subway Tile
Note: Precisely scribing and cutting the panel will provide a
clean 90 degree corner with no need for corner
molding.
Dust Hazard
When cutting or drilling the Swanstone
product, use a dust collection method which
prevents dust particles from going into the air. Always
work in a well-ventilated area. To keep the area well-
ventilated, open windows and use exhaust fans. Always
use an OSHA approved dust mask when cutting, drilling,
or sanding Swanstone products.
3. Place the wall panel, nished side facing up, on a at
surface. Place pieces of masking tape over the area where
the saw contacts the Swanstone panel.
4. Cut the panel using a circular saw with a 60-80 tooth
carbide blade or a saber saw with a bi-metal blade (14 teeth
per inch).
5. Measure the openings for the tub/shower faucet(s) and/or
shower head.
6. Transfer the measurements to the panel.
7. Cut clearance holes using a router, saber saw, or hole saw.
Drill or cut from the nished side of the panel. For best
results, when drilling, place a scrap of wood beneath the
hole to ensure a clean cut.
WARNING
Swan 10 800-325-7008
Installation Procedure