&y Swan Q Product Warnings Q Safety Guidelines O Kit Contents O Required Tools O Preparation Tips QO Installation Procedure O Cleaning & Maintenance O Surface Repair O Warranty Information Bench Seat SB-1248 Form # 191
The Swan stone Assurance — if our product is properly installed and maintained, as stated in these instructions, it will not leak. Remember = Safety First IMPORTANT NOTICE _I The Swan Corporation, the makers of the Swan stone Wall Systems and Panels, cannot anticipate every possible circumstance that might involve a potential hazard during the installation of our product{s). The warnings and instructions in this installation guide are, therefore, not all-inclusive.
Safety Guidelines IMPORTANT NOTICE IMPORTANT NOTICE: Indicates that equipment or property damage can result if instructions are not followed. m Read and Understand the Manual Iris the responsibility of any individual who % installs or maintains this product to fully understand and follow proper installation and maintenance procedures. Be aware of the inherent dangers in the use of power tools when installing this product. Read and understand all Warnings, Cautions, and Important Notices in this manual.
Safety Guidelines Room Temperature Allow the Swan stone panel and silicone to adjust to room temperature for at least six hours before installation. The panel should be installed at temperatures not less than 65 degrees. Panels should not be installed in areas where the temperature may drop below freezing Failure to follow this recommendation could adversely affect the silicone which holds the panels to the mounting surface. WARNING: situation which, if not avoided, could result in serious injury or death.
General Information Required Tools O Circular saw with 60 to 80 tooth carbide blade QO Tape measure Q Masking tape (2" wide works best) O Caulking gun o Color Match Caulk or Sealant’ O Clean paper towels or shop towels © 100% Ci ear Silicone Sealant Kit Contents Confirm that all parts of this kit have been included before beginning installation. $B-1248 Bench Seat Kit long x 14 wide x thick; 16.5 Abs) 1 Seat Panel x 48" x 0.
Instructions for Covering Pr-Existing Installation Procedure wan surfaces Swan stone panels can be installed over a variety of products. If you intend to apply the panels to any surface other than those described, consult with a professional contractor. Use the following sections when installing this product over: O SHEETROCK/GREENBOARD/CEMENTBOARD/ WOOD Sheetrock, Green board, Cement board, or Wood O Surface must be dry, smooth, and free of any dust, soap scum, or any other contaminants.
Installation Procedure 2. Construct the bench seat framework, as shown, using 2 x 4 wood or sire] studs. The framework for the seat must be deep and can be up fo long, depending on your application. IMPORTANT NOTICE The center braces are necessary to adequately support the weight placed on the seat. Failure to install these braces will void any product warranty. skim 3. In order fo eliminate standing water on the bench seal, cut and place three, 2" wide shims on top of each shown.
Installation Procedure 6. Cut the deaf panel to length. A H g Bic Es 90 NOTE: The length of the seat can vary, depending on the amount of desired overhang and the type of material used to cover the end of the bench. The width of the seat is precept to to provide a 172" overhang. Fumes Hazard The fumes from the silicone and solvents used by the installer can be harmful if used in an ventilated room, Always work in a well-ventilated area, 7.
Installation Procedure Maintenance & Surface Repair 10. Apply & bead of the color-matched 100% silicone sealant ~ on the top edges of the bench seat. Alec apply a bead of the color-matched 100% silicone sealant under the front edge of the seat panel. BECAME The installation is now complete. DO NOT discard these installation instructions. PLEASE LEAVE THEM WITH THE HOMEOWNER.
Warranty LIMITED WARRANTY FOR RESIDENTIAL APPLICATIONS If a Swan stone product covered by this warranty is found to be defective in materials or workmanship, after inspection by an authorized Swan Corporation representative, we will repair, or at our option, exchange the product for a similar model. This warranty extends for a designated period of time, so long as it remains in use in fts originate place of installation.
Save these installation Instructions for future reference. They provide important information on cleaning, maintenance, and surface repair of the Swan stone Wall Systems and Panels. Swan CORPORATION www.swanstone.
