Installation Guide

Dust Hazard
When cutting or drilling the Swanstone
product, use a dust collection method
which prevents dust particles from
going into the air. Always work in a well-ventilated area.
Always use an OSHA approved dust mask when cutting,
drilling, or sanding Swanstone products.
3. Dry fit the soap dish prior to applying clear silicone.
If the wall is not exactly 90 degrees square, it will be
necessary to sand the sides of the soap dish in
order to achieve proper fit, using a course grit
(60 grit) sandpaper.
4. Apply clear silicone to the edge of the soap dish.
5. Align the soap dish with the level-lines and press it
into place.
6. Hold the soap dish securely in place and wipe off
excess clear silicone. You will want a uniform bead
on both top and bottom.
7. Temporarily secure the soap dish with masking tape,
as shown. Remove the tape after approximately two
hours. Do not place anything on the soap dish for at
least 24 hours.
WARNING
The Swan Corporation – Swanstone 8 800-325-7008
Installation Procedure