Installation Guide

Soap Dish Installation
The soap dish is a corner mount design. The soap
dishes can be stacked in one corner or placed in
opposite corners.
Note: The current production soap dish is molded with a
square corner (as shown in the illustrations). This shape
requires installation of the optional corner molding after
installation of the soap dish. If your kit contains a sculpted
corner soap dish, the optional corner molding should be
installed before the soap dish. When the current stock of
sculpted corner soap dishes is exhausted, this design will
no longer be available.
Cleaning Wall Panel
Fumes Hazard
The fumes from the silicone and
solvents used by the installer can be
harmful if used in an unventilated room.
Always work in a well-ventilated area. To keep the area
well-ventilated, open windows and use exhaust fans. If
adequate ventilation is not achievable or practical, use
respiratory protective equipment.
Clean each wall panel with denatured alcohol or another
non oil-based cleaning solvent where the soap dish will
be installed.
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the
panel from adhering properly to the wall.
Installation of Square Corner Soap Dish
1. Select a desirable height for mounting one or both
soap dishes. A height of at least 43” from the
shower floor to the soap dish is recommended.
2. After marking the height, draw a 4” level-line on both
walls. These lines will be used to align the top
edges of the soap dish.
43"
IMPORTANT NOTICE
WARNING
Installation Procedure
800-325-7008 7 The Swan Corporation – Swanstone