Installation Guide

WARNING: Indicates a potentially hazardous
situation which, if not avoided, could result in serious
injury or death.
Fire Hazard
Personal injury or death can
result from a fire caused by
flammable liquids or silicone
sealants. Cleaners or solvents can be highly explosive,
resulting in personal injury or even death, when not used
properly. Clean up any flammable substance
immediately. Sparks or open flames can cause
flammable substances to ignite. DO NOT smoke while
working on or near any flammable substance.
Solvents Hazard
Follow all manufacturer’s safety instructions for
silicone sealants and denatured alcohol.
Alcohol vapors are both flammable and
hazardous to breathe. Silicone vapors may irritate eyes
and nose. Personal injury can result from improperly
handling or use of products such as denatured alcohol.
Always follow the manufacturer’s recommendations for
the safe use of these products. Ventilate any work area
before beginning to apply silicone sealants, cleaning
agents, or solvents.
Fumes Hazard
The fumes from the silicone and
solvents used by the installer can be
harmful if used in an unventilated
room. Always work in a well-ventilated area. To keep
the area well-ventilated, open windows and use exhaust
fans. If adequate ventilation is not achievable or
practical, use respiratory protective equipment.
Dust Hazard
When cutting or drilling the Swanstone
product, use a dust collection method
which prevents dust particles from
going into the air. Always work in a well-ventilated area.
Always use an OSHA approved dust mask when cutting,
drilling, or sanding Swanstone products.
Power Tool Hazard
To prevent personal injury or possible
death, always follow the electrical safety
recommendations of the power tool’s
manufacturer. Do not use power tools in an unsafe
manner. Power tools should only be connected to a circuit
protected by a ground-fault circuit interrupter (GFI).
Shock Hazard
Never use electric power tools around
water, condensation, or other liquids.
Electric shock can cause severe
burns, significant injuries, and even death. If an
extension cord is required, always use an OSHA
approved extension cord. Power cords should only be
connected to a circuit protected by a ground-fault circuit
interrupter (GFI).
Electrical Shock Hazard
Contacting l
ive electrical wiring with
power tools or hand tools can cause
serious injury or death. Make sure all
related circuit breakers are turned OFF. Test for live circuits
or wiring inside any wall where installation of the
Swanstone product requires cutting into a wall.
Electrocution Hazard
Water and other liquids conduct electric
current and can create a short circuit,
resulting in injury or death. Keep all
liquids away from electrical cords and power tools. DO
NOT create a short circuit between a source of electricity
and a liquid by being in contact with both simultaneously.
WARNING
800-325-7008 5 The Swan Corporation – Swanstone
Safety Guidelines