Quick Start Guide

What are the additional connections for?
Audio Input: For connecting a microphone (the
microphone must have its own power source).
Audio Output: For connecting to a stereo or amplifier.
This is not required when using the HDMI port.
PTZ Port: For connecting RS-485 compatible devices.
VGA Port: Connect this to your monitor with a VGA
input (VGA cable not supplied). This is not required
when using the HDMI port.
Connect the video output on the video
& power cable to each camera input
(VIDEO INPUT) on your DVR. Twist the
connection to lock it in place.
Connect the supplied Ethernet cable
to the Ethernet port (LAN) on your
DVR then connect the other end to a
spare port on your router.
Connect the supplied mouse
to the USB port.
To copy recorded events and to
perform a firmware upgrade, connect
a storage device such as a USB flash
drive (not included) to the front ports.
Connect the supplied HDMI cable
to the HDMI port on your DVR then
connect the other end to a spare HDMI
input on your TV.
Press the A/V button on your TV’s
remote to select the HDMI input
your DVR is connected to.
Connect the supplied power adapter’s
power connection to the power input
(12V) on your DVR first (this will
minimise sparking). Connect the
power adapter to a spare power outlet.
Your DVR is designed to ventilate air
to keep it at an optimal temperature.
Keep both sides of your DVR free from
obstructions to allow it to ventilate.
The bullet camera has three points
of articulation. Use a Phillips head
screwdriver to loosen the screw then
adjust to the desired position. Tighten
the screw again to secure in place.
Mounting and aiming the dome
camera
1. Hold the dome enclosure (1) and
the dome ring (2) then rotate the
mounting bracket (3) clockwise to
remove it from the camera.
2. Run the cable as required and
using the appropriate screws for the
surface you are mounting to, screw
the bracket (4) to fasten.
3. Place the camera into the dome
enclosure and dome ring and aim the
camera to the desired position. After
you’ve finished adjusting the viewing
position, rotate the dome ring to the
mounting bracket counter clockwise
to lock the position in place.
Positioning the bullet camera
To avoid damage, don’t
position the camera without
loosening the screws first.
This enables you to rotate
the camera left or right.
This enables you to position
the camera up or down.
Loosen the locking screw
counter clockwise to rotate
the camera stand left or right.
Tighten to secure in place.
1
2
3
Power Input
Video Output
Twist to lock
connectors
Video Input
Video & Power Cable
Connect this to your DVR
Power Splitter
connects here
Power Output
Power Adapter
connects here
Power Splitter
Power Adapter
Video & Power Cable
connects here
Connect to a spare
power outlet
US B
Internet
4
3
2
HDMI IN 1
HDMI IN 2
Power Adapter
2
4
3
5
Ethernet Cable
+ -+ -
12V12V
RS485RS485
LANLAN
1 3 5 7
2 4 6 8
VIDEO
INPUT
VIDEO
INPUT
AUDIO
INPUT
AUDIO
INPUT
AUDIO
OUTPUT
AUDIO
OUTPUT
VGAVGA
1 2
3
4
5
HDMI Cable
1
Bullet Camera
1
3
2
4
1
1
2
3